P25D2
Exhaust Camshaft Actuator Park Lock Control Circuit High (Bank 1)
P25D2 is set when the bank 1 exhaust phaser lock control line carries more voltage than the controller allows in the current switching state, for example because it is shorted to an ignition-fed wire or the solenoid's return is tied to supply. Most output stages detect overcurrent here and switch off, so the lock solenoid loses its command and the pin goes to the position its spring defines. The engine then runs with a fixed exhaust cam until the fault clears. No manufacturer publishes material for P25D2; the explanation uses the J2012 title, CARB's demand for electrical monitoring of output components in variable valve timing systems, and the working principle of locking phasers. Unlike the Low code, a short to power can also damage the driver.
Possible causes
- Lock control wire shorted to an ignition-fed circuit high
- Solenoid return path shorted to supply medium
- Damaged output stage in the engine control module low
Symptoms
- Check engine lamp on
- Weaker mid-range pull
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25D2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.