OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25CE

Intake Camshaft Actuator Park Lock Control Circuit Low (Bank 2)

P25CE stands for a low signal on the lock control line of the bank 2 intake phaser: the wire or the solenoid winding has found a path to ground, or the module's output is stuck pulling low. Because the second bank's harness often runs along the back of the engine or under the intake manifold, chafing at brackets and heat damage are frequent findings. A grounded line may hold the lock solenoid energised permanently, leaving the pin withdrawn when the engine is shut down, which can cause a clatter on the next cold start. GM's 15OBDG01 table includes P25CE in the intake phaser fault groups that disable the other phaser monitors, without its own limits. Codes for both banks at once suggest a shared supply or low battery voltage rather than two bad solenoids.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / CE

Possible causes

  • Bank 2 harness chafed through at a bracket high
  • Shorted winding in the bank 2 lock solenoid medium
  • Low system voltage setting lock codes on both banks low

Symptoms

  • Check engine lamp on
  • Clatter at cold start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25CE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication