OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25CC

Intake Camshaft Actuator Park Lock Control Circuit High (Bank 1)

With P25CC the controller sees the intake phaser lock control line on bank 1 sitting higher than expected, typically because it touches a live wire or the solenoid's ground path is shorted to supply. A protected output stage usually shuts down when it detects this, which leaves the lock solenoid without control: the pin falls back to whatever its spring dictates, and the intake phaser is then often parked at its locked base timing until the next restart. The GM 15OBDG01 table for the 2015 Volt and ELR counts P25CC among the intake phaser bundles that block further phaser diagnostics, but publishes no detection limits. Under CARB rules a circuit fault on such an output must be detected and stored. Inspect the harness near hot or moving parts first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / CC

Possible causes

  • Lock control wire shorted to a supply voltage high
  • Harness insulation melted near the exhaust or turbo medium
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine lamp on
  • Sluggish response with intake timing fixed

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25CC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication