OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25CB

Intake Camshaft Actuator Park Lock Control Circuit Low (Bank 1)

P25CB points to a control line for the intake phaser lock on bank 1 that reads lower than it should, most often a short to ground on the wire or inside the lock solenoid. Depending on how the driver is wired, the solenoid may then stay energised or never receive current, so the lock pin is either released all the time or cannot be pulled back. Released permanently, the phaser can rattle at start before oil pressure arrives; stuck in, it keeps the intake cam at its base timing. GM's 2015 Volt and ELR OBD table 15OBDG01 places P25CB in the intake phaser fault bundles that pause the related phaser checks, without listing a threshold. CARB requires circuit checks on such output components. Low voltage events can set several lock codes together.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / CB

Possible causes

  • Lock control wire shorted to ground high
  • Internal short in the lock solenoid medium
  • Weak battery or voltage dip during cranking low

Symptoms

  • Check engine lamp on
  • Brief rattle from the timing drive at start
  • Reduced power with fixed intake timing

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25CB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication