P25CA
Intake Camshaft Actuator Park Lock Control Circuit/Open (Bank 1)
Some cam phasers carry a locking pin that holds the rotor in a fixed base or middle position for starting and while oil pressure is still building. Where that pin is released and engaged by its own solenoid, the controller supervises this extra circuit. P25CA reports that the lock control circuit for the intake phaser on bank 1 is open or otherwise not behaving electrically, so the lock can no longer be operated on command. GM's 2015 Volt and ELR table 15OBDG01 lists P25CA among the intake phaser fault groups that suspend the other cam phaser diagnostics; it gives no thresholds of its own. Passive designs such as BorgWarner's mid-position lock for Hyundai lack this circuit. Expect rough starts or idle and limited cam timing.
Possible causes
- Open winding in the intake phaser lock solenoid high
- Connector off or terminal pushed back after engine work medium
- Broken wire between module and lock solenoid medium
Symptoms
- Check engine lamp on
- Rough start or unsteady idle
- Intake cam timing held at a default position, less power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25CA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.