P25C8
Brake Booster Temperature Sensor A Circuit Intermittent/Erratic
P25C8 is meant for a sensor A signal that drops out briefly or jumps faster than any real temperature in the booster could change, the typical footprint of a loose pin, a cracked solder joint or a wire that breaks under vibration. Each event may be too short for the low or high check to confirm, which is why this separate code exists. No manufacturer documents P25C8 publicly. GM's 2023 Corvette tables only confirm hard faults, requiring five consecutive out-of-range readings within 0.6 s for P25C6 or P25C7, so a fault that comes and goes might remain hidden there. Because an electromechanical booster such as Bosch's iBooster can also build brake pressure on its own for assistance systems, a jittery temperature input may make the unit limit its motor torque at unexpected moments.
Possible causes
- Loose or spread terminal in the booster connector high
- Wire breaking intermittently under vibration medium
- Cracked solder joint inside the booster electronics low
Symptoms
- Brake warning that appears and disappears
- Occasional change in pedal feel
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P25C8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.