P25C7
Brake Booster Temperature Sensor A Circuit High
P25C7 flags a sensor A signal that is too high; GM interprets it as the temperature line shorted to supply. In the EBCM part of table 23OBDG07 for the 2023 Corvette Z06 the voltage must exceed 3.27 V five consecutive times within 0.6 s with the ignition on, and the fault is Type B with two trips to the MIL. Tables 24OBDG07 and 25OBDG03A repeat these values. Beyond a real short, an open sensor or a broken ground can also pull the signal toward the top of the range on many sensor designs, so the wiring at the booster deserves a check before the unit is replaced. Its second sensor uses the slightly lower limit of 3.14 V and the chassis code C057A. P25C6 is the low-side counterpart.
Possible causes
- Sensor signal shorted to the supply line high
- Open sensor circuit or missing sensor ground medium
- Temperature sensor open internally medium
Symptoms
- Check engine lamp after two trips
- Brake system warning message
- Reduced brake assistance possible
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P25C7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.