P25C6
Brake Booster Temperature Sensor A Circuit Low
P25C6 means the signal of brake booster temperature sensor A is too low, which GM describes as the sensor line being shorted to ground. GM uses the code on the 2023 Corvette Z06 (table 23OBDG07, EBCM section) and keeps the same logic in its 2024 and 2025 tables 24OBDG07 and 25OBDG03A: the check runs continuously with the ignition on, needs the condition five times in a row within 0.6 s and is rated Type B, so the MIL comes on after two trips. The voltage limit for the low side is left blank in the published tables. A low reading can also come from a pinched harness at the booster, from water in the connector or from a sensor that has failed internally. The sibling P25C7 covers a short to supply, C0579 the same fault on the second sensor.
Possible causes
- Sensor signal wire shorted to ground high
- Moisture in the booster connector medium
- Internal short in the temperature sensor medium
Symptoms
- Check engine lamp after two trips
- Brake system warning message
- Brake assistance may be limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P25C6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.