P25C3
Alternative Fuel Disable Signal Circuit Low
P25C3 is logged when the alternative fuel disable signal reaching the engine controller is too low to be valid. A short to ground on the way from the gas system, a gas controller that has lost its supply, or a damaged output stage in that controller can each pull the line down. On a gas installation that announces a block by grounding the line, this would also be indistinguishable from a genuine stop request, so the engine controller has to treat gas operation as unavailable. GM's 2016 bi-fuel trucks illustrate the fallback: they start on gasoline and only change over once the conditions for gas operation have been met, and a failed changeover is shown with the fuel indicator. No manufacturer documents P25C3 publicly. The general signal fault is P25C1, the opposite case P25C2.
Possible causes
- Signal wire shorted to ground high
- Gas controller without supply voltage medium
- Damaged output stage in the gas controller low
Symptoms
- No change-over to gas operation
- Fuel mode indicator flashes or shows a fault
- Check engine lamp
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25C3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.