OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25C0

Alternative Fuel Disable Control Circuit Low

P25C0 is set when the alternative fuel disable output reads too low, typically a short to ground somewhere between the engine controller and the gas system. With a high-side driver that pin would then be unable to deliver its voltage; with a low-side driver the line would look permanently switched. The practical risk lies in which state the gas system reads as safe: if a missing block signal were taken as permission, gas could be released when the controller wants it off, so controllers generally stop gas operation as soon as such a fault is confirmed. CARB requires every 2019 and later alternate-fueled vehicle to run under an approved monitoring plan, which is where checks like this belong. No manufacturer documents P25C0 publicly; the open circuit is P25BE, the high fault P25BF.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / C0

Possible causes

  • Control wire shorted to ground, often where routed along the frame high
  • Chafed insulation on a retrofit gas kit harness medium
  • Output stage in the engine controller damaged low

Symptoms

  • Vehicle refuses to switch to gas
  • Fuel system fault message or flashing fuel indicator
  • Check engine lamp

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25C0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication