OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25BC

Regeneration Control Switch Circuit High

P25BC is the high-voltage counterpart: the regeneration switch line carries a level near supply voltage that no switch position can produce. A wire chafed against a battery or ignition feed, water in a switch connector or a switch whose internal resistor network has failed are plausible causes. If the switch requests regeneration by pulling the line up, a stuck high could resemble a permanent start command. That matters because a parked regeneration raises idle speed and exhaust temperature sharply; GM bulletin 20-NA-203 tells drivers to stand on level ground outdoors, clear of anything that can burn. Without a reliable switch the engine controller has to rely on automatic regeneration while driving. No manufacturer documents P25BC publicly, so repair follows the vehicle's wiring diagram.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / BC

Possible causes

  • Switch signal wire shorted to battery or ignition voltage high
  • Moisture in the switch connector medium
  • Internal fault in the switch or its resistor network medium

Symptoms

  • Regeneration switch ignored by the engine controller
  • Unexpected regeneration messages in the cluster
  • Check engine lamp

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P25BC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication