P25B8
Auxiliary Ignition Switch On/Start Position Circuit Low
P25B8 means the auxiliary On/Start input sits at a low level when the module expects it to be active, or never rises when the remote switch is operated. Typical reasons are a switch contact that no longer closes, a blown fuse feeding the remote panel, a broken wire in the long harness run to the body or a short to ground at a frame connector. In practice it behaves like a dead remote switch: requests from the auxiliary position are ignored, so a crew working at the body or platform cannot start the engine or keep it on from there. As no maker publishes this code, the GM main-switch case serves as reference, where GM's brake control module needs its wake-up line low for 3 s against a run/crank message from the ECM before logging P2534 as a Type B fault. P25B9 covers the opposite direction.
Possible causes
- Blown fuse or failed relay feeding the auxiliary switch high
- Signal wire shorted to ground on the frame or body medium
- Auxiliary switch contact no longer closes medium
- Corroded exterior connector with high resistance low
Symptoms
- Remote start or on request is ignored
- Engine may shut down when the auxiliary position is used to keep it running
- Remote panel indicator stays dark
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P25B8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.