OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P25A0

Turbocharger B Boost Control Position At Low Limit

P25A0 says the regulator of turbocharger B has run to its low limit without reaching the boost target, so the second charger delivers too little pressure even with full control authority. It only exists on engines where two chargers are regulated separately. No manufacturer documents P25A0 publicly. CARB 13 CCR 1968.2 requires a fault once boost feedback control has used all of its adjustment and still misses the target, which describes this case. For the A side, Ford flags the same situation as P259E when requested boost exceeds measured boost by 120 kPa on its 6.7 L diesel for about 10 s. Leaks between charger B and the intake, a sticking wastegate or vanes and sensor errors are the usual suspects. P25A1 is the high-limit partner, P259E the turbocharger A version.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / A0

Possible causes

  • Leak in the charge air path served by charger B high
  • Wastegate or vanes of charger B not closing as commanded medium
  • Worn or damaged charger B low

Symptoms

  • Engine warning lamp on
  • Lower power than usual, uneven pull

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P25A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication