OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P259D

Excessive Time To Enter Closed Loop Turbocharger B Boost Control

P259D is the turbocharger B version of the closed-loop timing fault. On engines with two separately regulated chargers, the control unit expects the boost regulation of the second unit to switch to feedback operation within a set time, and here it did not. No manufacturer documents P259D publicly with thresholds; the basis is CARB 13 CCR 1968.2, which asks for a malfunction when feedback boost control does not start in time or falls back to default operation. GM's 2018 diesel table illustrates the dependency on the A side: its actuator plausibility checks only run while VGT position feedback is active and no fault is present on the position sensor or the actuator circuit. A stored sensor or actuator fault on charger B is therefore the first thing to repair. P259C covers turbocharger A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 9D

Possible causes

  • Fault on position or pressure sensing for charger B high
  • Actuator B or its control circuit faulty medium
  • Leak in the charge air path of charger B low

Symptoms

  • Engine warning lamp on
  • Reduced power, especially at higher load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P259D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication