P258E
PTO Enable Switch Performance
P258E is the plausibility check of the power take-off enable switch. The line is not open or shorted – those faults are P251A to P251C – but the state of the switch does not fit the other PTO inputs, for instance an enable request without a valid arming step or contact signals that contradict each other. GM lists P258E among the PTO module codes in UI Bulletin 80C for Silverado and Sierra chassis cabs: the in-cab rocker delivers three mode signals that the module decodes so that every press is cross-checked, and an upfitter's remote enable switch only works if the arming button was pressed within five seconds before. GM warns upfitters against load-engage switches because they defeat these diagnostics. The truck still drives; the PTO refuses to engage or drops out.
Possible causes
- PTO switch contacts worn or contaminated, mode signals disagree high
- Upfitter wiring or load-engage switch interfering with the enable input medium
- Remote enable used without arming sequence or with wrong switch type medium
- PTO module configuration not matching the installed switches low
Symptoms
- PTO cannot be switched on or switches off unexpectedly
- Driver information message about PTO conditions
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P258E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.