OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P258C

Vacuum Pump Control Circuit A Low

P258C reports that control circuit A of the electrically driven vacuum pump reads too low, typically because the control or relay line is shorted to ground, the relay coil is faulty, or a blown supply fuse leaves the monitoring line without voltage. Depending on how the circuit is laid out, the pump may then run nonstop or not at all. No manufacturer publishes P258C itself. Ford's hybrid OBD summary shows the kind of window used on this circuit for P258A and P258B: the monitoring voltage should stay between 1.3 and 5.0 V with the relay off and must not drop below 250 mV with it on. CARB 13 CCR 1968.2 treats such electrical outputs as comprehensive components. P258A is the open circuit, P258D the high side; if braking assist suffers, P050F for low brake vacuum can follow.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 8C

Possible causes

  • Control or relay wire shorted to ground high
  • Blown vacuum pump fuse medium
  • Faulty pump relay or relay coil medium

Symptoms

  • Engine or brake warning lamp on
  • Pump silent or running constantly
  • Firmer brake pedal

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P258C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication