OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P257E

Engine Hood Switch Circuit Low

P257E says the hood switch signal has dropped below its lowest valid level, which usually means the signal wire touches ground or the switch is shorted inside. GM's 2018 engine table 18OBDG04 sets it for a resistance-coded switch at 325 ohms or less, the 2019 hybrid table 19OBDG01 at 14.6 % of range or less, each with 80 failures in 100 samples and Type B. A Chrysler STAR case for the 2017–2018 Pacifica describes a lit hood ajar lamp, a dead stop-start system and P257E after a repair, caused by the hood ajar plug and the horn plug at the latch having been swapped – a dead horn gives it away. GM's engineering note PIE0834 lists the code on its 2022–2025 electric pickups and SUVs with front hood latch trouble. Depending on design a grounded line can look like an open hood.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 7E

Possible causes

  • Hood switch signal wire chafed to ground near the latch high
  • Hood switch and horn connectors swapped after front-end repair medium
  • Switch shorted internally by water or impact damage medium

Symptoms

  • Hood ajar indicator on with the hood shut
  • Engine stop-start inoperative
  • Check engine lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P257E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication