P256D
Engine Idle Speed Selector Sensor/Switch Circuit High
P256D is logged when the idle speed selector signal rises above the highest value the controller treats as valid. Causes include a wire chafed against a battery-fed circuit, an open sensor return that lets the input float high, or an accessory module that drives the line with system voltage. No manufacturer documents P256D publicly. On GM's 6.6L Duramax trucks covered by PIT4529D, the standard elevated idle lifts engine speed to 1050 rpm only below 0 °C outside and with coolant under 65 °C, and owners can switch it off; a selector fault should not be confused with that intended behaviour. P256C is the low-side counterpart and P256E the intermittent variant. Usually the raised idle cannot be selected, while normal driving is unaffected.
Possible causes
- Selector wire chafed against a battery-fed circuit high
- Open return line letting the input float high medium
- Accessory module feeding system voltage into the line low
Symptoms
- Raised idle cannot be selected
- Normal driving unaffected
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P256D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.