P2565
Turbocharger Boost Control Position Sensor A Circuit High
P2565 means the boost actuator position signal sits above the highest plausible value, typically from an open signal wire, a short to the 5 V reference or battery voltage, or a failed sensor. GM's 2018 diesel ECM table flags it at an analog reading above 95 % in 200 of 250 samples (Type A, warning lamp on the first trip). Kia service action SA149 for the 2011-2012 Sportage 2.0 T-GDI pairs P2565 with P2562, updates the engine software and adjusts the wastegate rod until the position reading lands between roughly 3.8 and 4.1 V, depending on coolant temperature. Ford special service message 53328 offers a separate vane actuator for 2020-2022 F-Super Duty 6.7 L diesels showing P2564/P2565 among other codes. P2564 is the low-side fault. Power is usually limited.
Possible causes
- Open signal wire or unplugged actuator connector high
- Signal wire shorted to the 5 V reference or battery voltage medium
- Wastegate actuator rod set to the wrong length (electric wastegate engines) medium
- Failed vane actuator with integrated sensor low
Symptoms
- Loss of power, sometimes limp mode
- Check engine light on
- Unusual turbocharger noise on some diesels
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2565
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.