OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2564

Turbocharger Boost Control Position Sensor A Circuit Low

P2564 is stored when the voltage from the boost actuator position sensor stays below the lowest value a working sensor can deliver, which usually points to a short to ground or a lost reference supply. GM's 2009 Duramax table uses 0.277 V (5.5 %, vanes fully open) held for 1 s once the engine has run 3 s, Type B. Ford's 2023 diesel OBD summary checks the signal continuously against 0.15 V over 2 s, and VW's 2014 Passat book applies the same 0.15 V limit on the 2.0 L TDI and calls it a short to ground. FCA bulletin 09-003-16 for the 2015-2016 Jeep Renegade 1.6 L sold in EMEA lists P2564 with P2565 and replaces the turbocharger. P2565 is the high-side counterpart, P2563 a position error with a usable signal. Expect reduced power.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 64

Possible causes

  • Signal wire chafed through and touching ground near the turbocharger high
  • 5 V reference supply to the sensor missing or shorted medium
  • Failed position sensor or vane actuator medium

Symptoms

  • Noticeable loss of power or limp mode
  • Check engine light on
  • Other sensors on the same 5 V supply may report faults too

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2564

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication