P255C
PTO Speed Selector Sensor/Switch 2 Circuit Low
P255C means the input of PTO speed selector 2 reads lower than the controller's bottom limit, usually because the signal wire has a short to chassis ground or the switch is shorted inside. On designs where a grounded line is itself the command, as with the switch-to-ground inputs of Ram's 2017 VSIM, a short looks exactly like a permanently held preset 2 request; the controller can only tell the difference when the selector is resistor-coded or monitored with a diagnostic current. No manufacturer publishes P255C. P255D is the high-side fault on the same input, P254C the low fault on selector 1. Possible results are an engine that stays at the second working speed whenever PTO is active, or a PTO that the controller blocks.
Possible causes
- Selector 2 wire shorted to chassis ground high
- Selector 2 shorted internally medium
- Harness pinched under a body mounting low
Symptoms
- Engine always runs at the second preset in PTO mode
- PTO blocked
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P255C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.