OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2551

Torque Management Request Input Signal B High

P2551 is the high-side fault of torque request B: the signal sits above the top of its valid window. Typical electrical causes would be a line touching a battery feed, an interrupted reference ground or a sender that drives its output to full scale. Because an unexpectedly high request could translate into unwanted torque, the engine module discards it and works without channel B. No maker documents P2551 publicly. GM's ECM table 17OBDG04 shows that a vehicle can fill channel B with the brake and traction module's request and validates it with protection value and message counter under P2548, with no separate high code. CARB requires monitoring of such electronic inputs whenever a failure could raise emissions or blind another monitor. P2550 is the low-side fault, P2547 the high fault on input A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 51

Possible causes

  • Request line shorted to battery voltage medium
  • Open ground or reference at the sender medium
  • Requesting module drives its output to full scale low

Symptoms

  • Check engine light depending on make
  • Traction control warning, engine ignores intervention requests

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2551

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication