OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2550

Torque Management Request Input Signal B Low

P2550 marks the second torque request input, B, as stuck below its lower limit. A hard-wired line would be pulled to ground by chafed insulation or a fault in the sending stage; in a networked design the sender would be reporting a value that lies under the bottom of the defined range. The engine module then disregards input B and keeps running on its own torque calculation. No maker documents P2550 publicly. GM's 2019 table 19OBDG03A assigns the B channel to the traction request of the electronic brake and traction control module, sent in messages $1C8/$237, and checks it only with the general code P2548. CARB requires electronic inputs to be monitored for out-of-range values when they influence emissions. P2551 is the high-side fault, P2546 the low fault on input A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 50

Possible causes

  • Request line chafed through and shorted to ground medium
  • Output stage of the requesting module defective medium
  • Corroded or water-logged connector low

Symptoms

  • Check engine light depending on make
  • Traction-related torque reduction no longer applied

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2550

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication