P254D
PTO Speed Selector Sensor/Switch 1 Circuit High
With P254D the controller sees the PTO speed selector 1 input above its upper limit. Causes are a signal wire rubbing against a battery-fed circuit, a broken ground or sensor return that lets the line float to the pull-up voltage, or a selector supply that is too high. Deutz separates these on its multi-stage speed selector: P3045-12 for a short to battery and P3045-A1 for a supply voltage outside its range. In GM's 2008–2014 chassis-cab PTO system a remote set input above 3.33 V is a valid choice, Set Speed 2 at 1700 rpm by default, which again shows that only a coded selector can flag this state. No manufacturer publishes P254D. P254C is the low-side counterpart. Operators notice the PTO jumping to the highest step or not engaging.
Possible causes
- Signal wire shorted to a battery-fed circuit high
- Open ground or return line letting the input float high medium
- Selector supply voltage too high low
Symptoms
- PTO jumps to the highest preset speed
- PTO does not engage
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P254D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.