P254C
PTO Speed Selector Sensor/Switch 1 Circuit Low
P254C reports that the signal from PTO speed selector 1 sits below the lowest voltage the controller accepts, which in practice means the signal wire touches ground or the switch is shorted internally. Whether a maker can detect this at all depends on the design. In GM's UI Bulletin 80c a grounded remote set input is simply read as a request for Set Speed 1, factory 1250 rpm, so a chafed wire would quietly raise engine speed instead of setting a code; a resistor-coded selector leaves room for a separate fault band. Deutz records the same condition on its multi-stage selector as P3045-11, short to ground. No maker publishes P254C itself. The opposite fault, a reading above the top limit, is P254D. Expect PTO speed stuck at one step or PTO disabled.
Possible causes
- Selector signal wire chafed through to ground high
- Internal short in the selector switch medium
- Water in an exterior selector connector low
Symptoms
- PTO speed stuck at one step
- PTO blocked by the controller
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P254C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.