OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2547

Torque Management Request Input Signal A High

P2547 is logged when torque request A sits above the highest value the receiving module will accept. A wired input would read like a line touching a supply voltage or a lost ground at the sender; a bus message would carry an out-of-scale number. The receiver ignores such a request, since following it could mean an unwanted torque increase. No maker documents P2547 publicly. How input A is checked can be seen in GM's 2020 table 20OBDG04, where the engine module tests the transmission module's torque messages for protection value, rolling counter and an upper torque limit of 1,298 Nm, but under the general code P2544 rather than a separate high code. CARB requires such inputs to be monitored when they affect emissions or other diagnostics. P2546 is the low side, P2551 the high fault on input B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 47

Possible causes

  • Request line shorted to a supply voltage medium
  • Requesting module sends a value above the scale medium
  • Poor ground at the requesting module low

Symptoms

  • Shift-related torque reduction no longer works, firmer shifts
  • Check engine light depending on make

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2547

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication