OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2546

Torque Management Request Input Signal A Low

P2546 says that torque request A, the channel over which one module asks another to raise or cut engine torque, reads below its permitted floor. On a hard-wired request this points to a line pulled toward ground; on a data-bus request it means a value pinned at or under the minimum the receiver accepts. Jaguar is the clearest user: SSM73594 (December 2017) covers the 2018MY E-Pace with the ZF 9HP48 nine-speed, whose transmission module stores P2546-86, sometimes together with P2545-86, while the root cause was still being investigated. The dealer sequence is leak check, oil level, newer TCM software, then clear and only call technical assistance if it returns; Land Rover issued a matching note, SSM73291, for its own 9HP48 models. P2547 is the high-side counterpart. Drivers may notice rough or delayed shifts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 46

Possible causes

  • Outdated transmission module software (JLR 9HP48 remedy) high
  • Oil leak or low oil level in the transmission medium
  • Wired request line shorted to ground low

Symptoms

  • Harsh or delayed gear changes
  • Transmission warning message or check engine light
  • Fault often stored together with P2545

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2546

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication