OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2539

Low Pressure Fuel System Sensor Circuit

P2539 is the general circuit code of the sensor that reports the supply pressure ahead of the high-pressure pump. In VW's 2014 specification books for the Passat, CC and Touareg it is set once the signal exceeds 4.80 V, which the Passat book attributes to a broken line or contact with the positive supply; below 0.2 V VW stores P2541 instead. Deutz's EMR controller files P2539-F0 for a ground fault of the supply pressure sensor. Ford's 2015 Transit with the 3.2 L Duratorq TDCi has a pressure switch: per SSM 51033, units built from 6 March 2015 may log P2539 in a key-on engine-off self-test because no switch change is seen after shutdown, and the code can be ignored if the engine-running test and the MIL are clean. P2540 to P2543 narrow the fault down. Without the signal, supply pressure control runs on a substitute value.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 39

Possible causes

  • Signal or ground wire open, connector not engaged high
  • Signal wire shorted to the 5 V reference or battery voltage medium
  • Failed low-pressure fuel sensor or pressure switch medium
  • Code logged only in a static self-test without a real fault (Ford Transit 2015) low

Symptoms

  • Check engine light
  • Hesitation or reduced power under load
  • Hard starting, especially after standing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2539

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication