P2537
Ignition Switch Accessory Position Circuit Low
P2537 reports that the accessory or accessory wake-up input sits low where a high level is expected. GM documents it in detail: on the 2016 Volt the ECM fails it when the accessory input is false while the propulsion system has been active for more than 0.5 s; it is a Type B fault over 2 trips, and the 6-speed TCM tables evaluate the same input with no MIL. GM bulletin PIT5308 for 2014–2015 Silverado, Sierra, Tahoe, Yukon, Suburban and Escalade links P2537 to remote start, and a power liftgate that only works with the ignition on, because ECM and TCM do not get the 12 V accessory wake-up from the BCM on circuit 5985; that wire is checked with a voltmeter, not a test lamp. A diesel follow-up (PIT5308A) adds a blower that keeps running after shutdown.
Possible causes
- Open or high-resistance accessory wake-up circuit between BCM and ECM/TCM high
- Body control module not driving the wake-up output medium
- Poor terminal contact at ECM or TCM connector medium
Symptoms
- Remote start inoperative
- Power liftgate works only with ignition on
- Blower may keep running after engine shutdown (diesel)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2537
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.