OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2534

Ignition Switch On/Start Position Circuit Low

P2534 is the most widely documented of this group. GM's 2025 tables let the TCM fail it when its run/crank input is false while the ECM reports run/crank active, 99 failures out of 240 samples at 25 ms, Type A; the brake control module (EBCM) sets it when its primary wakeup line reads low for 3 s while the network says run or crank, Type B. On the 2016 Volt the line must drop below 2.0 V for 2.5 s. GM bulletins name an ECM harness rubbed through where it passes the left upper control arm bracket on 2020–2025 Silverado/Sierra 2500HD/3500HD (24-NA-124: MIL, stall, no start) and a TCM recalibration for 2008 CTS/STS with the 6L50 (PIP4276B). Ram's 08-037-21 lists it for the 2021 eTorque 1500. Ford's 2014 BOSS 302S table carries it without the M marker.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 34

Possible causes

  • Engine harness chafed at a bracket (GM HD trucks, upper control arm bracket) high
  • Run/crank relay or fuse open medium
  • Module software needing an update (GM 6L50 TCM, Ram eTorque HCP) medium
  • Loose terminal on the wakeup line at TCM or BCM low

Symptoms

  • MIL on
  • Stall or no start
  • Transmission or other modules set follow-up codes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2534

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication