P252C
Engine Oil Quality Sensor Circuit Low
P252C is stored when the oil quality sensor's signal sits below the range the engine computer accepts. Typical reasons are a signal wire chafed through to ground, a supply line that has lost its voltage or an internal short in the sensor; depending on the input circuit an open wire can also drag the reading down. As the sensor is mounted on the oil pan, its connector lives in a hot, oily and splash-prone spot, which makes corrosion and damaged insulation likely suspects. No manufacturer publishes a voltage threshold or a service bulletin for this code. CARB asks for circuit checks of such inputs only if the component can affect emissions or serves another monitor, so many applications leave the MIL off. P252D is the high-side counterpart, P252A the general circuit fault. The oil condition value disappears.
Possible causes
- Signal wire chafed against the oil pan or engine block (short to ground) high
- Sensor supply voltage missing (fuse, supply wire) medium
- Internal short in the oil quality sensor medium
Symptoms
- Oil condition value missing in the cluster or service menu
- Service reminder falls back to fixed intervals or shows a fault
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P252C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.