P2529
Vacuum Reservoir Pressure Sensor Circuit Intermittent
P2529 covers a vacuum reservoir pressure signal that drops out or jumps for short moments rather than staying wrong. The engine module notices changes faster than a reservoir could physically empty or fill, or brief excursions to the electrical limits that recover again. Loose terminals, a cracked wire flexing with the engine, a harness rubbing on the pump bracket or moisture entering the connector are typical, and the fault often vanishes in the workshop. No maker documents P2529 publicly. CARB still expects circuit monitoring of such comprehensive component inputs, and the reservoir itself is the vacuum store a separate pump keeps up. Steady faults are P2527 and P2528.
Possible causes
- Loose or spread terminal in the sensor connector high
- Harness chafing or wire breaking under engine movement medium
- Moisture entering the connector low
Symptoms
- Check engine light comes and goes
- Occasional brief loss of power or boost
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2529
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.