P2528
Vacuum Reservoir Pressure Sensor Circuit High
P2528 is logged when the vacuum reservoir pressure sensor delivers a voltage near or at its supply, beyond anything the sensing element can output. A signal wire touching 5 V or battery voltage, a broken sensor ground, or corrosion bridging pins in the connector are the classic findings. A real loss of vacuum does not normally push the signal this far; it would appear as a range or performance fault instead. No vehicle maker documents P2528 publicly, so this rests on CARB's demand that comprehensive component inputs be checked for circuit faults, and on how such reservoirs work: a pump, often on the camshaft of diesels and hybrids, keeps them evacuated for the brake booster and actuators. P2527 is the low extreme, P2529 an intermittent signal. Expect default actuator control.
Possible causes
- Signal wire shorted to 5 V or battery voltage high
- Sensor ground open medium
- Corrosion bridging pins in the connector low
Symptoms
- Check engine light depending on maker
- Reduced power with actuators in default position
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2528
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.