OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2527

Vacuum Reservoir Pressure Sensor Circuit Low

P2527 means the signal from the vacuum reservoir pressure sensor has fallen below the lowest voltage a working sensor can produce. Whether low volts stand for deep vacuum or for atmospheric pressure depends on the sensor curve, but a reading at the floor is treated as an electrical fault, not as a vacuum value. Likely causes are a signal line shorted to ground, an open line on a sensor with pull-down, a missing 5 V reference, or a dead sensor. The 2004–2006 Dodge Sprinter is the documented case: FCA's emissions recall T21 names P2527 among the codes that may appear once the corrected engine software is installed; voltage thresholds were not published. P2528 is the high-side counterpart, P2526 a plausible voltage with an implausible value. Vacuum actuators may then run open-loop.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 27

Possible causes

  • Signal wire shorted to ground high
  • 5 V reference open or pulled down medium
  • Sensor without output medium

Symptoms

  • Check engine light
  • Boost or EGR control in default mode, less power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2527

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication