P2523
A/C Request B Circuit Low
P2523 reports that A/C request input B is pulled below its valid range. On the wire level this usually means a conductor grounded against body metal, a sending module whose output transistor has failed shorted, or a wet connector draining the signal. Whether the engine module then assumes a constant request or none depends on the circuit design, and no maker states it publicly; P2523 has no codegenau manufacturer documentation. The regulatory basis is CARB's A/C component monitoring, required only where the A/C changes fuel or spark control. Cars that receive the request over CAN, like the 2011 Saab 9-5, cannot set it. P2522 is the generic circuit fault on B, P2524 the high side, and P2520 the same low fault on input A. Expect missing or unwanted compressor operation.
Possible causes
- Input B wire shorted to ground high
- Output stage of the sending module shorted medium
- Moisture in a connector of the request line low
Symptoms
- Compressor not engaging or engaging unasked
- A/C-related idle compensation missing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2523
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.