OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P251D

PTO Engine Shutdown Circuit/Open

P251D covers the engine shutdown line of a power take-off installation. On trucks with body equipment such as cranes, pumps or aerial devices, a hard-wired signal lets the PTO controller or an equipment stop button tell the engine module to switch the engine off. P251D means the module cannot read a valid state on that line, usually because the wire or plug is open. No manufacturer documents P251D publicly or states how the engine reacts; the description rests on CARB's PTO definition and on GM's PTO bulletin PIP6108, which shows how ground and harness faults upset PTO circuits. Depending on calibration the PTO may be locked out, or a stop request from the equipment may no longer reach the engine. P251E and P251F name a fixed low or high level.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number5 / 1D

Possible causes

  • Open shutdown wire or loose connector at the body interface high
  • Fault in the body equipment's stop switch or controller output medium
  • Shutdown input enabled in calibration but not wired by the upfitter low

Symptoms

  • PTO locked out or equipment will not run
  • Equipment stop button no longer shuts down the engine

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P251D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication