P250C
Engine Oil Level Sensor Circuit Low
P250C means the oil level sensor's signal line is pulled too low, the classic picture of a short to ground or, depending on the input design, a break that lets the line drop. Deutz describes its P250C-00 the same way: level sensor line grounded or interrupted. Hyundai shows that software can trip it too: on 2023 Kona and Elantra with the 2.0 L Nu Atkinson engine, P250C turned on a warning lamp, and the cure was a PCM reflash that changes how the oil level warning is triggered. Ford also lists P250C for the 2014 BOSS 302S engine module. The opposite fault is P250D, dropouts are P250E. A low level of oil itself is P250F. For the driver the oil level information is lost.
Possible causes
- Signal wire shorted to ground near the sump high
- Open circuit or unplugged sensor connector medium
- Warning logic in the engine module, fixed by reflash (Hyundai 2.0 Nu) medium
- Sensor electronics shorted internally low
Symptoms
- Oil level warning lamp on
- No oil level reading in the cluster
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P250C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.