P24F8
Exhaust Aftertreatment Fuel Air Purge Valve Control Circuit
P24F8 is the electrical fault of the fuel/air purge valve: the control unit finds the solenoid drive circuit not working, typically an open wire or a coil that draws no current. Volvo and Mack report it as P24F813, the suffix 13 meaning open circuit. In their AHI diagnosis guide for US10+OBD13 engines onward it stands in the electrical fault table together with P24FA and P24FB, and the prescribed work is the AHI module connector and the harness, not the air or fuel supply. The dosing module carries the valve; on newer trucks it sits on the fuel filter housing. While the valve cannot be driven, the doser line is not blown clear after dosing, which puts filter regeneration at risk. CARB's heavy-duty rules require actuators like this to be checked for circuit continuity.
Possible causes
- Broken wire or chafed harness between engine controller and AHI module high
- Corroded or loose plug at the AHI dosing module medium
- Interrupted coil of the purge valve solenoid medium
Symptoms
- Warning lamp right after the circuit test runs
- Active regeneration blocked or incomplete
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P24F8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.