P24F4
NOx Sensor Delayed Response - High to Low (Bank 1 Sensor 1)
P24F4 concerns the dead time of the upstream NOx sensor on bank 1 when engine-out NOx falls, typically on lift-off into overrun: the reading stays put too long before it starts dropping, even if the later descent is normal. CARB defines this split for exhaust sensors, delayed response being the wait before the first reaction and slow response a sluggish transition. No manufacturer documents P24F4 publicly. GM's 2025 diesel table shows the method for the rising edge: inside the front-sensor test P22F9 a timer runs from the NOx model reaching 30 ppm until the sensor does, and over 2 s is a fault. Hella names deposits and ageing as reasons for late NOx readings. P22FA is the slow falling case, P24F5 sensor 2.
Possible causes
- Soot or oil ash on the diffusion barrier of the front sensor high
- Aged measuring cells reacting late to falling NOx medium
- Exhaust leak ahead of the sensor distorting the transient low
Symptoms
- Check engine light on
- Front NOx value lingers on lift-off
- Engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24F4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.