P24F1
Control Module Wake-up Circuit High
With P24F1 the wake-up line carries voltage while its driving module has the output switched off, so a short to a battery feed or a second source keeps it live. GM's HPC2 module in the 2016 and 2019 hybrid tables flags 13.21 V or more in the off state, using the same 480-of-560 sample count at 12.5 ms and Type A, MIL after one trip. Mercedes-Benz documents P24F100 in the 8-speed dual-clutch gearbox controller of CLA, GLA and GLB (XENTRY tip LI27.19-P-080869, 2026): the wake line appears shorted to positive, the car may briefly refuse to start, and the cause is signal timing with the ignition switch module, fixed by new SCN coding of that unit. P24EF is open, P24F0 low.
Possible causes
- Wake-up line shorted to a battery feed high
- Signal timing between ignition module and receiving unit, solved by coding medium
- Voltage fed back from another module that stays awake low
Symptoms
- Check engine light and several warning messages
- Temporary no-start condition
- Possible battery drain while parked
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P24F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.