P24E2
NH3 Sensor Circuit Range/Performance
P24E2 flags an NH3 sensor whose signal is electrically valid but makes no sense: the ammonia value sticks, drifts or contradicts what the dosing model expects from the SCR catalyst. On heavy trucks the sensor is a smart unit with its own electronics that test probe and circuitry and report over J1939. Navistar lets this self-test run on the 2013 N13 only after the middle of the SCR brick has stayed above 170 °C for five seconds, and lights the MIL after two failed trips. No manufacturer publishes P24E2 with thresholds. CARB's heavy-duty rule obliges makers to check such sensors for rationality. Wiring faults are P24E3/P24E4, dropouts P24E5. The driver sees a warning lamp; DEF dosing becomes less precise.
Possible causes
- Sensing element aged or poisoned by deposits, giving a drifting ammonia value high
- Urea crystals around the sensor tip after overdosing medium
- Exhaust leak near the sensor diluting the sample low
Symptoms
- Check engine light after two trips
- DEF consumption noticeably higher or lower than usual
- Possible ammonia smell at the tailpipe
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P24E2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.