P24DA
Particulate Matter Sensor Exhaust Sample Error Bank 1
P24DA checks that the particulate matter sensor actually samples exhaust gas, which is how the system detects a sensor that has been pulled out, sits in a blocked protection tube or is mounted wrongly. Ford's 2023 diesel summary runs it once per drive in protective heating mode and fails it if the summed sensor voltage change during exhaust flow changes stays under 0.5 V, over about 3 minutes. GM's 25OBDG04A table watches filtered heater power, sets the code below 1.66 and rates it Type A, so the lamp comes on after one trip. Bulletin 18-2225 lists P24DA among the codes cured by a new sensor on 2017–2018 Super Duty diesels. Because a sensor outside the exhaust would hide a failed filter, the code counts as emissions-relevant; P2002 reports the filter itself.
Possible causes
- Protection tube clogged high
- Sensor removed from the exhaust or installed wrongly medium
- Sensor no longer responding to exhaust flow medium
Symptoms
- Malfunction indicator lamp on
- Particulate filter monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24DA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.