P24D8
EVAP System Pressure Sensor/Switch B Circuit High
P24D8 reports EVAP pressure sensor B reading above its valid voltage. In GM's 2023 table 23OBDG03A the canister pressure sensor fails above 4.85 V, 97 % of the reference, counted over 640 of 800 samples and treated as Type B. Mitsubishi's 2023 Outlander PHEV applies 4.1 V for 2 s to its absolute tank pressure sensor, which shows about 101 kPa at sea level when healthy. Audi's bulletin 2069531 lists P24D8 as pressure sensor 2 shorted to positive and also shows it among codes logged under a wrong label, to be tested as sensor G950. Common findings are an open sensor ground, a signal wire touching the 5 V or 12 V supply, or an internal failure. Compare P24D7 for the low side.
Possible causes
- Open ground of sensor B, signal floats high high
- Signal wire shorted to reference or battery voltage medium
- EVAP pressure sensor B failed medium
Symptoms
- Malfunction indicator lamp on
- EVAP readiness monitor incomplete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24D8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.