P24D1
Particulate Matter Sensor Regeneration Incomplete
Before each measurement the particulate matter sensor heats its element to burn off collected soot. P24D1 means that this cleaning phase did not finish properly. Ford's 2023 diesel summary flags the code when the sensor cannot return to measuring after regeneration, judged over 120 s. GM's 18OBDG04 table fails it when the electrode stays at or below 775 °C for 43 s during steady regeneration (25OBDG04A: 715 °C), Type B, and calls it heater degradation. Ford special service message 49846 replaces the sensor on 2017–2019 Super Duty and F-650/750 6.7L trucks, and FCA lists P24D1 for 2019 Jeep Compass diesels in bulletin 18-008-23 (PCM update). P24B7 points to a heater resistance fault, P24AF to an implausible electrode during cleaning.
Possible causes
- Sensor heater degraded, not reaching cleaning temperature high
- Heavy deposits on the sensor element medium
- Control software needing an update low
Symptoms
- Malfunction indicator lamp on
- Particulate filter monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24D1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.