P24CA
Particulate Matter Sensor Temperature Circuit Intermittent
P24CA is reserved for a PM sensor temperature reading that fails only now and then instead of staying out of range. No manufacturer documents this code publicly. For comparison, Ford's 2023 diesel summary treats any temperature signal outside 0.3 to 3 V for 2 s as P24C6, and GM's 25OBDG04A table uses a counter of 24 failures within 96 samples for P24C9, so short glitches can stay below those limits. CARB requires circuit faults of PM sensors to be detected. Intermittent faults of this kind usually come from a cracked solder joint, a connector that loosens with heat or a lead that chafes on the exhaust. The warning lamp may come and go, and while the reading is doubtful the soot filter check is put on hold. P24C6, P24C8 and P24C9 are the steady faults.
Possible causes
- Connector loosening when hot high
- Lead chafing on the exhaust medium
- Cracked joint inside the sensor lead low
Symptoms
- Malfunction indicator lamp coming and going
- Particulate filter monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24CA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.