P24C2
Exhaust Gas Temperature Measurement System - Multiple Sensor Correlation Bank 1
Diesel exhaust lines often carry three or four temperature probes in a row, ahead of the oxidation catalyst, the particulate filter and the SCR catalyst. P24C2 says that on bank 1 the readings of these probes no longer agree with each other, without pinning the error on one of them. Ford's 2023 diesel summary uses it in its EGT plausibility check: after a soak of at least six hours with the engine stopped, all probes should read alike at key-on (limit 50 °C), and during the following 200 to 400 s each probe is compared with a model (±80 °C), with a fault having to persist for 20 s. Ram lists the code in bulletin 18-028-14 for the 2014 Ram 1500 with the 3.0 L diesel, cured by new PCM software. Single-probe faults are P2080, P2084, P242B and P246F. Filter regeneration may be held back.
Possible causes
- One exhaust temperature probe has drifted with age and reads too high or too low high
- Corroded or heat-damaged connector adding resistance to one probe signal medium
- Engine control software with too tight correlation limits (update available on some models) medium
- Probes swapped between mounting positions after a repair low
Symptoms
- Malfunction indicator lamp on
- Particulate filter regeneration suppressed or aborted
- Often no noticeable change in driving behaviour
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P24C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.