P24BE
EVAP System Leak Detection Pump Switching Valve Control Circuit Low
P24BE says the voltage on the switching valve control line is too low while the valve should be idle. Mitsubishi documents it for the 2023 Outlander PHEV: the valve sits in the ELCM leak check unit, is supplied by the MFI relay and grounded by a transistor in the engine computer, and the code sets when the line reads 3 V or less for 2 s with the valve not commanded. That pattern fits a missing relay supply, an open coil or a control wire shorted to ground. As a fail-safe the car stops purging, keeps the fuel filler door shut and shows a refuelling-system service message. P24BF is the over-current counterpart, P24BD the general circuit code; the related 0.020 inch leak test cannot finish meanwhile.
Possible causes
- No supply from the relay to the valve (fuse, relay, wire) high
- Switching valve coil open inside the module medium
- Control wire between module and ECM shorted to ground medium
Symptoms
- Malfunction indicator lamp on
- Fuel filler door does not open with the opener switch
- Refuelling system service message on the display
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24BE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.