OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P24BD

EVAP System Leak Detection Pump Switching Valve Control Circuit/Open

P24BD points to the drive circuit of the switching valve inside the leak check module. This small solenoid moves the canister vent path between open air and the reference orifice, so the module can first measure a known leak and then test the real system. The code stands for an open or generally faulty control circuit. No manufacturer documents P24BD publicly; Mitsubishi's 2023 Outlander PHEV splits the same valve into P24BE and P24BF, where the valve is fed from a relay and switched to ground by the engine computer. CARB requires output components like this to be checked for circuit faults. Without a working valve the leak test cannot run; in Mitsubishi's design purge is blocked and the fuel door stays locked.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / BD

Possible causes

  • Switching valve coil open inside the leak check module high
  • Open control or supply wire, blown fuse or relay fault medium
  • Corroded connector at the module medium
  • Output driver in the engine control module faulty low

Symptoms

  • Malfunction indicator lamp on
  • EVAP leak test does not run
  • On some designs fuel door locked or purge disabled

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P24BD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication