OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P24BC

EVAP System Leak Detection Pump Pressure Sensor Circuit Intermittent

P24BC is meant for a pressure signal from the leak check module that drops out or jumps briefly, too short to latch the low or high limit. No manufacturer documents P24BC publicly. The closest published logic is Mitsubishi's noise check on the same sensor in the 2023 Outlander PHEV, which counts signal crossings during the engine-off test and fails above 20 events, but Mitsubishi reports that under P24B9. CARB expects EVAP sensors to be watched for circuit faults as well as erratic behaviour. Because the fault comes and goes, check the harness near the canister and fuel tank for chafing, water in the connector and loose terminals before replacing the module. Steady faults are P24BA (low) and P24BB (high).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / BC

Possible causes

  • Loose or spread terminal in the leak check module connector high
  • Harness chafing near the canister or tank, intermittent short or break medium
  • Water or corrosion in the module connector medium
  • Sensor in the leak check module failing intermittently low

Symptoms

  • Malfunction indicator lamp on, sometimes going out again
  • EVAP readiness monitor completes only occasionally

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P24BC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication