OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P24BA

EVAP System Leak Detection Pump Pressure Sensor Circuit Low

P24BA reports that the voltage from the leak check module's pressure sensor has fallen below the lowest value a working sensor can produce. In GM's ELCP tables (2018 Volt) the limit is 0.70 V, about 14 % of the reference or roughly 47 kPa absolute, with 640 failures in 800 samples taken every 12.5 ms; the check runs whenever the controller is awake and is Type B. Mitsubishi's 2023 Outlander PHEV sets P24BA when the signal stays under 0.1 V for 2 s. Subaru asks technicians to clear P24BA before chasing P2404 in the ELCM. A low signal mostly means a lost 5 V reference, a signal wire shorted to ground or a dead sensor. P24BB is the high-side counterpart; the leak test is suspended until the fault is gone.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / BA

Possible causes

  • Sensor signal wire shorted to ground high
  • 5 V reference open or pulled down by another sensor on the same supply medium
  • Pressure sensor inside the leak check module failed medium

Symptoms

  • Malfunction indicator lamp on
  • EVAP leak test not run

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P24BA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication